We hold no responsibility for the destruction that follows. Load the funnel with a water balloon-and let it fly. Stand behind the frame, grasp the balloon holder's handle, and pull down at an angle. Place a balloon in the launcher, pull down on the handle, aim, and fire Your balloon soars high through. Tie two 24-inch lengths of surgical tubing through the grommets and the eyebolts. Each battle station has a water balloon launcher. In response, Andrew throws a bunch of cans of beer at the kid in the house throwing water balloons. Then 'Andrew' on the bike gets pelted by a water balloon. The camera guy/car owner starts to film the interaction. Slide 6-inch piece of hose onto rope push rope's ends through narrow end of funnel and hole in fender washer. Andrew crashes into a PT cruiser because hes drunk and dodging water balloons. Make the Water Balloon Holderīut your work isn't done yet, you'll need something to hold those latex and rubber bombs.įirst, drill two 1⁄2-inch holes opposite each other into a funnel, 1 inch from top fit grommets into holes. Use the carabiners and chains to connect the eyebolts, and now you've made a water catapult that'd make any medieval monarch jealous. Screw an eye lagbolt into each leg, 36 inches from bottom. Use three washers per side, one each between the eye and the inside leg, the two legs, and the wingnut and the outer leg. This will be the back.Ĭonnect the two assemblies by fitting the narrower one inside the other, lining up the 5⁄16-inch holes and putting the eyebolts through the holes, with the eye on the inside.
Mark the narrow side of each leg 18 inches from the bottom, line up the crossbeam with the marks, and fasten it with one screw on each side. Now lay the other two legs on a level surface, parallel and with the outer edges 46 1⁄2 inches apart.
0 kommentar(er)
